The K4392V2-H M7240 is often confused for the name of either the Honeywell 6150 Keypad or the Honeywell 5828 Keypad. This plastic door is completely optional on both keypads, and it can be removed if desired. TELCO FAULT (Or CHECK 94): The telephone line has a problem.A Honeywell K4392V2-H M7240 is the part name of the small plastic flip-down door that covers the push buttons on both the Honeywell 6150 Hardwired Keypad and the Honeywell 5828 Wireless Keypad.Long Rng Trbl (or bF): If installed, there is an issue with long-range communication.OPEN CIRCUIT (or OC): The Keypad is not communicating with the main control panel.If this is displayed for more than 1 minute, contact FMC’s service department. Busy-STANDYBY (Or dl): Indicates the system is disabled.AC LOSS (Or NO AC): Indicates the system is operating on Battery Power due to a lack of AC power to the system.BELL FAILURE (or CHECK 70): Indicates a wiring issue with the external sounder/siren.MODEM COMM (or 91): Indicates that FMC is currently connected with the system remotely.ALARM 1xx FAULT 1xx CHECK 1xx (Or CHECK 90): Indicates a communications fault with the device listed.RCVR JAM: The wireless receiver is experience difficulty communicating with the devices installed in your property.Many Wireless Sensors can be changed by the user, but if you are unsure, please call our service department. LO BAT + Zone: A Low Battery Condition Exists on the Zone Described.SYSTEM LO BAT: A system Low battery condition is present, and the back-up battery on the system will need to be changed by an FMC Security Technician.COMM FAILURE (or FC): A problem with the telephone line which is communicating alarms to our monitoring station.If they are present, please call for service: The following trouble conditions could also be present on the alarm system.If the display persists, please contact our service department. If you have wireless sensors, ensure environmental conditions are not an issue and if the problem has been corrected, the display can be cleared if you enter the OFF sequence (security code plus OFF key) twice.If the problem has been corrected, the display can be cleared if you enter the OFF sequence (security code plus OFF key) twice. If you are unsure, please contact our monitoring station.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |